Link 1: Observe the car body; Check for damage

This step must be the first step before all construction starts. After completing this link completely and carefully, you can effectively check out the damaged parts, record and feed back to the customer for confirmation, to avoid conflicts that occur later. And the construction scheme can be confirmed from it and confirmed with the customer. If the vehicle has been patched, the owner should be informed that the invisible car coat can be patched as much as possible to avoid the peeling of the patched car paint.

 

Link 2: Careful car washing

This detail determines the success or failure of aesthetics after construction. It is necessary to completely ensure that the construction is free of sediment, oil stain, adhesive and other sundries, and ensure that the surface and details are free of any sundries, so that when the invisible car coat is pasted, it is more suitable, and it is not easy to produce bubbles, stains, spots, particles and other problems in the later stage. The door edge and other positions must be clean and free of stains, otherwise the warping and other problems may occur.

 

Link 3: Use professional construction fluid; Pre-cut film cutting

The construction part is preliminarily cut by using waste materials such as release paper, and the width of the edge is reserved. After cleaning the parts again, use professional construction fluid to spray the parts comprehensively to ensure the uniformity of all Pensa. The professional construction fluid can effectively improve the lubrication, facilitate the construction top position and water scraping, and use professional methods to drive the water, and paste the invisible car coat on the parts. This step needs perfect cooperation, and the construction fluid is constantly added between the paint surface and the invisible car coat, which can effectively avoid the subsequent problems such as degumming and offset printing.

 

Link 4: Car and clothing styling

There are edges and corners on the surface of the car body. TPU car clothing can be perfectly attached to any part according to its tensile property and viscosity. It is not necessary to heat or stretch more to shape, but only to leave enough materials for construction at the initial stage. Only poor-quality TPH products require the construction personnel to soften the film by heating to produce greater tensile properties attached to the surface. Excessive stretching and heating will only destroy the original performance of the invisible car coat. Remember not to overstretch.

 

Link 5: water drainage and corner treatment

After the invisible car clothing is positioned, the water can be drained through the scraper to drive away the construction fluid between the paint surface and the film. During the operation, the water needs to be drained from the inside to the outside to avoid blisters after repeated operation. The corner treatment can be carried out after the completion of water flushing. Cutting of redundant parts. By flushing the invisible car coat and the paint surface, the viscosity of the invisible car coat is increased. After binding and pasting, the moisture in the corners is dried through the baking gun. And confirm that the corners are pasted completely without warping.

After the completion of the five links, carry out a comprehensive inspection. The construction of the invisible car suit is an extremely complex and troublesome work, which is a highly demanding and stressful work for technicians. PUZEN carries out the spirit of Japanese craftsmen, and constantly trains technicians to pay attention to these five links, constantly improve the technical level of technicians, and more importantly, cultivate the care, patience and attention of the whole construction process.